Non Charging Adjustable Holder
Adjustable Height from 120 to 135mm
SKU:216336
Non Charging Adjustable Holder
Adjustable Height from 125 to 140mm
THE HOLDER
- The Holder can easily attach to our Dashmounts, Pedestal Mounts, Suction Mounts, Bar Mounts, and Forklift Mounts or form part of your kit.
- Comms ports, camera, and scanner buttons are accessible while docked.
FIRM & SECURE FIT
- Customised design to firmly hold your tablet.
DESIGNED TO BE USED WITH OR WITHOUT A CASE
- The holder can adjust from 125 to 140mm in Height. Max Thickness 10 to 17mm
- If you use a case, measure the device's height within the case BEFORE ORDERING.
AMPS PATTERN MOUNT HOLES
- Mounting the Holder onto a Headrest Mount, Pedestal Mount or Bar Mount is easy with the AMPS hole mounting plate.
OPTIMAL VIEWING
- Holders come with a tilt swivel that can rotate 360° and tilt the holder 17° in any direction for optimal viewing to avoid light reflection.
Please Note: Mounting a Tablet onto a ClicOn Dashmount is always done at the customer’s risk. Consideration should be given to the position and how firmly the dash mount holds the weight of a Tablet.
- The Holder
- Firm & Secure Fit
- Optimal Viewing
- AMPS Pattern Mount Holes
| This Holder Fits | Devices between 125 to 140mm high and 10,to 17mm Thickness |
| SKU | 216337 |
| Barcode # | 7320282163372 |
| Brand | ClicOn |
| Shipping Weight | 0.3210kg |
Below you will find the installation instructions for the Non Charging Adjustable Holder (SKU:216337), you can click on the images to open a larger version in a new tab
Step 1
1. To put the device in the holder: Place the device IN the holder. Press down HARD on the top of the holder. Slide the device sideways out of the holder. Tighten the screws with the short end of the Allen key.
Step 2
2. Loosen the screw in the middle of the holder so you can remove the mounting plate on the back. Place the mounting plate in the desired location. Secure the mounting plate with the supplied screws. Place the holder over the mounting plate, so the screw fits into the hole. Tighten the screw until the holder is firmly in place but can still be angled.
Step 3
3. To insert the device into the holder: Place the lower part of the device into the holder and press forward on the upper part of the device so that it snaps into the holder. To remove the device from the holder: Press upwards on the upper part of the holder and pull the upper part out of the holder first; then, you can lift the device out of the holder.
Step 4
The holder is fully assembled.
Our Price
$89.90
One Year Warranty
Free Shipping Over $110.00
30 Days Return Policy
Australian Owned & Operated
