Hard Wired Charging Adjustable Holder
ONLY for Devices with Micro USB
SKU:527620
Hard Wired Charging Adjustable Holder
ONLY for Devices with Micro USB
THE HOLDER
- Attach to the Mount to hold your device firmly & securely using the screws provided. The Holder can also form part of your solution.
FIRM & SECURE FIT
- Customised design to firmly fit and hold your smartphone securely.
DESIGNED TO BE USED WITH A CASE
- Dimension: Width 75-89 mm, Slot 12-16 mm
- If you are using a case make sure you measure the Width and Thickness of the device with the case on, BEFORE ORDERING.
HARDWIRE INSTALL
- Dual USB Port Hard-Wire Charger that supports Qualcomm QC 3.0A quick charge.
- Quick charge only, works with compatible devices.
- Green USB Port: QC 3.0A for a quick charge.
- White USB Port: 2.4A for charging a second device.
AMPS PATTERN MOUNT HOLES
- Mounting the Holder onto a Car Dashboard Mount is made easy with the AMPS hole mounting plate.
LANDSCAPE TO PORTRAIT
- All ClicOn holders come with a tilt swivel that can rotate 360° and tilt the holder 17° in any direction for optimal viewing and to avoid light reflection.
Please Note: This Holder connects directly to the vehicle's power. A professional installer is recommended.
- The Holder
- Firm & Secure Fit
- Dimension: Width 75-89 mm, Slot 12-16 mm
- AMPS Pattern Mount Holes
- Landscape to Portrait Viewing
| This Holder Fits | Width 75-89 mm, Slot 12 -16 mm |
| SKU | 527630 |
| Barcode # | 7320285276307 |
| Brand | ClicOn |
Below you will find the installation instructions for the Hard Wired Charging Adjustable Holder (SKU:527630), you can click on the images to open a larger version in a new tab
Step 1
1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle controlled by the ignition switch.
Step 2
How to mount the holder: 1. Use your phone to determine the direction of the charging connector in the holder. Place the charging connector into the locking block. Place the locking block in its position on the front of the holder. Turn the holder around and screw the locking block into place using the enclosed screws. 2. To adjust the holder for your device: Loosen the screws on the holder's front side, so the holder's sides can be adjusted. Place the device in the holder and press the sides together, so the device is firmly in place. Remove the device carefully. Tighten the screws on the front side of the holder.
Step 3
3. To install the holder: Loosen the screw in the centre of the holder, removing the tilt swivel attaching plate on the back. Screw the attaching plate onto the desired position with the enclosed screws. Place the holder over the attached container. Screw a few turns on the screw, so the thread starts to pull. Pull the holder toward you and hold it slightly tensed; at the same time, tighten the screw firm at first, then loosen it a bit so the holder is firmly in place but still can be adjusted.
Step 4
4. The holder is in place.
Our Price
$129.90
One Year Warranty
Free Shipping Over $110.00
30 Days Return Policy
Australian Owned & Operated
Customer Testamonials
More items from the same category
Previous
Next
